E 250 V8-4.6L VIN W (2006)
Disconnect the electronic throttle body (TB) electrical connector.
4. NOTE: The red clip must be pulled out before disconnecting the electrical connector.
Disconnect the throttle position (TP) sensor electrical connector.
5. Remove the 4 bolts and the TB.
-
Discard the TB gasket.
Installation
1. Install a new TB gasket, position the TB and tighten the 4 bolts in 2 stages.
-
Stage 1: Tighten to 9 Nm (80 lb-in).
-
Stage 2: Tighten an additional 90 degrees.
2. Connect the TP sensor electrical connector.
-
Push back the red clip.
3. Connect the electronic TB electrical connector.
-
Push back the red clip.
4. Install the air cleaner assembly and air cleaner outlet tube.
5. Connect the battery ground cable.