Edge AWD V6-3.5L (2009)
Disassembly and Assembly
1. Remove the 40 percent seat cushion. For additional information, refer to Seat Cushion - Rear, 40 Percent See: Removal and Replacement/Rear
Seats/Seat Cushion - Rear, 40 Percent.
2. Remove the 2 kneeling assembly-to-cushion frame bolts. Remove the kneeling assembly.
-
To install, tighten to 25 Nm (18 lb-ft).
3. Release all the cushion trim cover-to-cushion frame retainers and remove the cushion foam pad and cushion trim cover.
4. NOTICE: Use care when separating the cushion trim cover from the hook-and-loop strips, or the hook-and-loop strips can be torn from
the cushion foam pad.
Remove the cushion trim cover in the following sequence.
1. Feed the heater mat wire harness and electrical connectors back through the cushion trim cover (if equipped).
2. Release the hook-and-loop strips.
3. Separate the cushion trim cover wire retainer from the clips in the cushion foam pad and remove the cushion trim cover.
5. To assemble, reverse the disassembly procedure.
Seat Cushion - Rear, 60 Percent
Seat Cushion - Rear, 60 Percent
NOTE: A new heater mat will come assembled on a new foam pad.
