Edge AWD V6-3.5L (2009)
72. Detach all of the wiring harness retainers from the RH valve cover and stud bolts.
73. Disconnect the LH VCT solenoid electrical connector.
74. Disconnect the 3 LH coil-on-plug electrical connectors.
75. Detach all of the wiring harness retainers from the LH valve cover and stud bolts.
76. NOTE: LH shown, RH similar.
Remove the 6 bolts and the 6 coil-on-plugs.
77. Loosen the 11 stud bolts and remove the LH valve cover.
-
Discard the gasket.
78. Loosen the bolt, the 10 stud bolts and remove the RH valve cover.
-
Discard the gasket.
