Edge AWD V6-3.5L (2009)
35. Install the engine roll restrictor, transaxle bracket and the 3 bolts.
-
Tighten to 90 Nm (66 lb-ft).
36. Tighten the engine roll restrictor-to-subframe through bolt to 103 Nm (76 lb-ft).
37. Install the roll restrictor heat shield and the 2 nuts.
-
Tighten to 11 Nm (97 lb-in).
38. Position the Y-pipe assembly in place and install the 4 nuts.
-
Tighten to 40 Nm (30 lb-ft).
39. Install the 2 exhaust hangers and tighten the exhaust clamp.
-
Tighten to 40 Nm (30 lb-ft).
40. NOTE: Apply clean engine oil to the crankshaft front seal bore in the engine front cover.
