Edge AWD V6-3.5L (2009)
-
Is the voltage greater than 10 volts?
Yes
INSTALL a new bulb holder. TEST the system for normal operation.
No
GO to J7.
-------------------------------------------------
J7 CHECK THE SJB STOPLAMP OUTPUT CIRCUIT FOR A SHORT TO GROUND
-
Ignition OFF.
-
Disconnect: Trailer Tow Stop/Turn Relays.
-
Disconnect: SJB C2280d.
-
Measure the resistance between the SJB C2280d-25, circuit CLS18 (GY/BN), harness side and ground; or between the SJB C2280d-26, circuit
CLS19 (VT/OG), harness side and ground.
-
Is the resistance greater than 10,000 ohms?
Yes
GO to J11.
No
REPAIR the circuit in question for a short to ground. After the repair:
If no DTCs are present, TEST the system for normal operation.
If DTC B106E is present, CLEAR the DTCs and REPEAT the self-test (required to enable the stoplamp output driver if DTC B106E is present).
TEST the system for normal operation.
If DTC B106F is present, INSTALL a new SJB. TEST the system for normal operation.
-------------------------------------------------
J8 CHECK FOR VOLTAGE TO THE INOPERATIVE STOPLAMP
-
Disconnect: Inoperative Rear Lamp.
-
While applying the brake pedal, measure the voltage between the LH rear lamp C412-3, circuit CLS18 (GY/BN), harness side and ground; or
between the RH rear lamp C415-3, circuit CLS19 (VT/OG), harness side and ground.
-
Is the voltage greater than 10 volts?
