Edge AWD V6-3.5L (2009)
2. Rotate the TR sensor detent plate counterclockwise, as viewed from below until the plate rests against the transaxle case, remove the park pawl
actuating rod from the TR sensor and remove the TR sensor.
28. Using a suitable tool, remove the manual control lever shaft seal.
Installation
1. Using the Manual Lever Shaft Seal Installer, install a new manual control lever shaft seal.
2. Install the TR sensor.
1. Position the park pawl actuating rod in the TR sensor.
2. Install the TR sensor in the transaxle case.
3. Using the Manual Lever Retaining Pin Installer, install a new TR sensor locking pin.