Edge FWD V6-3.5L (2007)
All wheel drive (AWD) vehicles
7. Remove and discard the halfshaft nut.
^
To install, tighten to 275 (203 ft. lbs).
8. Using the special tool, separate the halfshaft from the hub and bearing.
All vehicles
9. Position a suitable jackstand under the lower arm.
10. Remove and discard the lower shock nut and flag bolt.
^
To install, tighten to 80 Nm (59 ft. lbs).
11. Remove and discard the upper arm outboard bolt and nut.
^
To install, tighten to 150 Nm (111 ft. lbs).
12. Remove and discard the toe link outboard bolt and nut.
^
To install, tighten to 150 Nm (111 ft. lbs).
13. Lower and remove the jackstand.
AWD vehicles
14. Position the halfshaft through the wheel knuckle opening and secure the halfshaft aside.
