Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
a)
Install the new safety belt buckle cover with the felt patch on the passenger side buckle assembly. Install four (4) supplied screws to secure
the cover and tighten the screws. See Figure 3.
b)
Install the other safety belt cover (without felt patch) onto the driver side seat belt assembly. Install four (4) supplied screws to secure the
cover and tighten the screws. The two remaining screws in the kit are spare screws.
4.
Buckle Operation Check 2:
With the new safety belt buckle covers in place, verify the operation of both safety belt buckles.
a)
Insert the safety belt tongue into the buckle. Make sure the buckle makes a "click" noise.
b)
Pull on the safety belt to make sure it is securely locked into the buckle.
c)
Push the buckle release button and make sure the buckle releases the safety belt.
d)
If the buckle fails to securely lock and retain the safety belt, call the Special Service Support Center at 1-800-325-5621.
NOTE:
Special Service Support Center will authorize replacement of the buckle assembly if the latch fails to operate properly. Replacement covers
must be installed on the new assembly to maintain uniform appearance.
5.
Move the seats back to their original positions.
