Escape 2WD L4-122 2.0L DOHC VIN B Zetec SFI (2003)
PROPERLY. BELT ASSEMBLIES NOT IN USE DURING A COLLISION SHOULD ALSO BE INSPECTED AND REPLACED IF EITHER
DAMAGE OR IMPROPER OPERATION IS NOTED.
NOTE: The driver side is shown, the passenger side is similar.
1. Remove the B-pillar trim panel.
2. Remove the safety belt anchor.
1
Using the special tool, remove the bolt.
2
Remove the safety belt anchor.
3. Separate the front safety belt retractor from the B-pillar.
1
Remove the bolt.
2
Using the special tool, remove the bolt.
3
Separate the front safety belt retractor from the B-pillar.
4. Remove the front safety belt retractor.
1
Disconnect the front safety belt retractor.
2
Remove the front safety belt retractor.
INSTALLATION
1. To install, reverse the removal procedure.
^
Make sure that after the front passenger safety belt retractor is installed, the retractor is not in the Automatic Locking Retractor (ALR) mode.
NOTE:
^
Make sure the safety belt webbing is not twisted prior to installation.
^
Make sure to tighten bolts to specification.
