Escape 2WD L4-2.5L Hybrid (2010)
Seat Track: Service and Repair
Seat Track
Seat Track
Removal and Installation
NOTE: For component identification and locations, refer to Seat - Exploded View, Front See: Service and Repair/Seat - Exploded View, Front.
1. Remove the front seat backrest. For additional information, refer to Seat Backrest - Front See: Seat Back/Service and Repair/Removal and
Replacement/Seat Backrest - Front.
2. Remove the safety belt buckle pretensioner.
-
Disconnect and detach the safety belt buckle pretensioner and buckle switch electrical connectors from the seat track.
-
Detach the wiring harness pin-type retainer.
-
Route the wiring harness from between the seat track and cushion frame.
3. Disconnect the electrical connectors, detach the wiring harness from the seat track.
-
If driver seat, disconnect the seat position sensor electrical connector.
-
If equipped, disconnect the power seat motor electrical connector.
-
Detach the seat harness electrical connector from the seat track.
-
Note wiring harness routing for correct installation.
4. Remove the 4 seat track-to-cushion frame bolts.
-
To install, tighten to 25 Nm (18 lb-ft).
5. To install, reverse the removal procedure.
-
Transfer components as necessary.
