ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 7561 > < Initial Inspection and Diagnostic Overview|Page 7559
Page 2
background image

-

Verify the vehicle is equipped with the compass feature.

-

Is the vehicle equipped with the compass feature?

Yes

REFER to Accessories and Optional Equipment to diagnose the FDIM display.

No

RETURN the vehicle to the customer and ADVISE them the vehicle is not equipped with a compass display feature.

-------------------------------------------------
A3 CHECK THE INTERIOR REAR VIEW MIRROR POWER CIRCUIT FOR VOLTAGE

-

Ignition OFF.

-

Disconnect: Interior Rear View Mirror C9012 (Without Camera Mirror, Without SYNC), C9030 (Without Camera Mirror, With SYNC) or C9039
(With Camera Mirror, With SYNC).

-

Ignition ON.

-

Measure the voltage between the interior rear view mirror, harness side and ground as follows:

-

Is the voltage greater than 10 volts?

Yes

GO to A4.

No

VERIFY the SJB fuse 41 (15A) is OK. If OK, REPAIR the circuit. If not OK, Refer to the Wiring Diagrams to identify the possible causes of the circuit
short. CLEAR the DTCs. REPEAT the self-test. TEST the system for normal operation.  See: Diagrams/Electrical Diagrams/Diagrams By Number

-------------------------------------------------
A4 CHECK THE INTERIOR REAR VIEW MIRROR GROUND CIRCUIT FOR AN OPEN

-

Ignition OFF.

-

Disconnect: Negative Battery Cable.

-

Measure the resistance between the interior rear view mirror, harness side and ground as follows:

Initial Inspection and Diagnostic Overview|Page 7561 > < Initial Inspection and Diagnostic Overview|Page 7559