Escape 4WD V6-3.0L (2008)
Connect - Type III
1. NOTE:
-
Apply clean engine oil to the end of the tube and the quick connect coupling O-ring seals.
-
Make sure the tube clicks into place when installing it into the quick connect coupling. To make sure the tube is fully seated, pull on the tube.
Install the quick connect coupling onto the tube until fully seated.
2. NOTE: Make sure the retainer clip clicks into place when installing.
Depress the retainer clip until it is flush with the quick connect coupling housing.
3. NOTE: To make sure the tube is fully seated, pull on the quick connect coupling.
Rotate the primary locking tab to the closed position.
Disconnect - Type IV
WARNING:
-
Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly
flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
-
Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result
in serious personal injury.
-
Before working on or disconnecting any of the fuel tubes or fuel system components, relieve the fuel system pressure to prevent accidental
spraying of fuel. Fuel in the fuel system remains under high pressure, even when the engine is not running. Failure to follow this
