Escape 4WD V6-3.0L (2008)
Disconnect - Type III
WARNING:
-
Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly
flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
-
Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result
in serious personal injury.
-
Before working on or disconnecting any of the fuel tubes or fuel system components, relieve the fuel system pressure to prevent accidental
spraying of fuel. Fuel in the fuel system remains under high pressure, even when the engine is not running. Failure to follow this
instruction may result in serious personal injury.
1. If servicing a liquid fuel tube quick connect coupling, release the fuel system pressure.
2. NOTE: Carefully release the lock tab to avoid breakage.
Release the quick connect coupling primary lock tab.
3. Rotate the primary lock tab to the fully un-locked position and squeeze the secondary lock tabs to release the locking mechanism.
4. NOTE: When reusing liquid or vapor tube connectors, make sure to use compressed air to remove any foreign material from the connector
retaining clip area before separating from the tube.
Disconnect the quick connect coupling from the tube.
-
Push the locking mechanism outward and separate the quick connect coupling from the tube.
