Escape 4WD V6-3.0L (2008)
Clutch Slave Cylinder: Service and Repair
Clutch Slave Cylinder
Material
Removal and Installation
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call. For additional information, consult the product Material Safety Data Sheet
(MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, wash it
immediately with cold water.
1. Remove the transaxle.
2. Disconnect the clutch slave cylinder-to-clutch hydraulic fluid tube adapter.
3. Remove the 3 clutch slave cylinder bolts and the clutch slave cylinder.
^
To install, tighten to 12 Nm (9 lb-ft).
4. To install, reverse the removal procedure.
^
Bleed the air from the system.
