Escort L4-116 1.9L VIN J FI HP (1988)
Figure 2
8.
To obtain the initial Suspension Height Measurement, substract Dimension B from Dimension A.
9.
To obtain the final Suspension Height Measurement, subtract the value found in the Fuel Load Correction Chart shown in Figure 2.
10.
Change left and right rear springs, as necessary. Proceed by using the following:
^
Use the suspension height measurement as noted
^
Use the Rear Spring Selection Charts, corresponding to the proper vehicle suspension as shown below.
REAR SPRING SELECTION CHART
1987/1988 1/2 SEDAN & 1987/88 STATION WAGON
STOCK R. SPRING
SUSPENSION HEIGHT
CODE ON DOOR VIN
SERVICE SPRING
MEASUREMENT
TAG (SEE FIG.3)
INSTALLATION
3.0 inches or higher
A
E1EC-5560-GB
J
E1EC-5560-FB
H
E1EC-5560-EB
G
E6EC-5560-KA
F
E6EC-5560-KA
2.5 inches to 3.0 inches
A
E1EC-5560-HB
J
E1EC-5560-GB
H
E1EC-5560-FB
G
E1EC-5560-EB
F
E6EC-5560-KA
M
E6EC-5560-KA
E
E6EC-5560-KA
2.25 inches to 2.5 inches
A
E1EC-5560-JB
(SEE NOTE BELOW)
J
E1EC-5560-HB
H
E1EC-5560-GB
G
E1EC-5560-FB
F
E1EC-5560-EB
M
E6EC-5560-KA
E
E6EC-5560-KA
NOTE:
VEHICLES WITH SUSPENSION HEIGHT MEASUREMENTS BELOW 2.25 INCHES DO NOT REQUIRE A SPRING CHANGE.
REAR SPRING SELECTION CHART
1988 1/2 STATION WAGON
STOCK R. SPRING
SERVICE
SUSPENSION HEIGHT
CODE ON DOOR VIN
SPRING
MEASUREMENT
TAG (SEE FIG.3)
INSTALLATION
3.0 inches or higher
3
E3EC-5560-AA
2
E6EC-5560-BA
1
E6EC-5560-BA
2.5 inches to 3.0 inches
3
E3EC-5560-BA