Escort ZX2 L4-2.0L DOHC VIN 3 (2000)
1. Dry set the windshield glass.
^
Position the windshield glass in the pinch weld.
^
Align the windshield glass from the bottom center point of the glass out to the two spacers at the bottom of the pinch weld.
^
Align the gap of the windshield glass at the top and sides of the back window glass edge to pinch the weld edge.
^
Mark the windshield glass and the body when aligned as specified.
^
Remove the windshield glass from the pinch weld and clean the back of the window glass inside perimeter with an alcohol-free cleaner and
wipe with a clean cloth.
NOTE: Keep glass and body surfaces free of dirt, water, and oil. Do not touch coated surfaces with your hands.
2. Trim the remaining urethane sealant on the pinch weld to the specified thickness.
CAUTION: Do not scratch the pinch weld area.
3. Using a wool applicator, apply the Urethane Metal Primer Essex U-413 meeting Ford specification WSB-M2G234-C to any exposed metal on the
pinch weld. Allow six to ten minutes to dry.
