Excursion 4WD V10-6.8L (2002)
7. Remove the rear corner trim panel.
8. Route the safety belt through the rear corner trim panel openings.
INSTALLATION
1. To install, reverse the removal procedure.
Crew Cab
REMOVAL
1. Remove the window regulator switch housing.
2. If equipped, remove the window regulator handle.
3. If equipped, disconnect the power window connector.
4. Remove the panel reflector.
5. Remove the screws.
6. Lift and remove the rear door trim panel.
NOTE: Remove the rear door trim panel by pulling it straight upward.
INSTALLATION
1. To install, reverse the removal procedure.
CAUTION: Insert the lower panel tabs first or they can break when installing the rear door trim panel.
SuperCab
REMOVAL
1. Remove the rear door window garnish moulding.