Excursion 4WD V10-6.8L (2002)
7. NOTE: Index-mark the driveshaft to transmission flange (manual transmission) or output shaft to slip yoke (automatic transmission).
For vehicles equipped with a manual transmission, remove and discard the bolts.
8. Remove the center bearing support bolts.
9. Remove the front driveshaft.
-
For vehicles equipped with an automatic transmission, lower the driveshaft and slide it rearward off the transmission output shaft.
-
Plug the extension housing to prevent fluid loss.
10. Clean grease deposits, dirt and rust from the following:
-
The driveshaft yoke areas.
-
All driveshaft components.
-
Wipe the bearing and rubber insulator of the driveshaft center bearing. Do not immerse in solvent.
11. Inspect the following:
-
The universal joint slip yoke boot for rips or holes. Install a new boot if necessary.
-
The driveshaft center bearing support for wear or rough action. If roughness or wear is evident, install a new driveshaft center bearing support.
-
The center bearing rubber insulator for evidence of hardening, cracking or deterioration. Install a new insulator if necessary.
Installation
1. For vehicles equipped with a manual transmission, align the index marks and connect the front driveshaft to the transmission. Install the new bolts.
-
Hand-tighten only; do not tighten at this time.
2. For vehicles equipped with an automatic transmission, align the index marks and slide the driveshaft slip yoke onto the output shaft.