Excursion 4WD V10-6.8L VIN S (2000)
Drive/Propeller Shaft: Service and Repair
Front
Removal
1. Raise and support the vehicle.
2. Index mark the front driveshaft to the front axle flange and at the transfer case flange.
3. WARNING: Replace with new bolts and retainers after the third removal.
Disconnect the front driveshaft from the front axle.
1. Mark and remove the driveshaft to front axle bolts.
2. Remove the U-joint retainers.
4. WARNING: Replace with new bolts after the third removal.