Expedition 2WD V8-281 4.6L VIN W EFI (1997)
(3) Rotate the driveshaft center yoke.
(4) Press out the remaining bearing cup.
-
Repeat to remove the spider from the driveshaft yoke.
ASSEMBLY
1. Install a new bearing cup into the driveshaft yoke.
(1) Start a new bearing cup into the driveshaft yoke.
(2) Position the new spider in the driveshaft yoke.
(3) Position the driveshaft in U-Joint Tool.
(4) Press the bearing cup below the yoke surface.
-
Repeat for the other side of the yoke.
2. Install the driveshaft center yoke.
(1) Position the driveshaft center yoke in U-Joint Tool.
(2) Press in a new bearing cup.
(3) Rotate the driveshaft center yoke.
(4) Press in the other new bearing cup.
3. Install four new snap rings.