Expedition 4WD V8-5.4L SOHC VIN 5 (2005)
9. Position the transmission cooler tube support bracket and install the nut.
^
Tighten to 10 Nm (89 inch lbs.).
10. NOTE: Lubricate the O-ring seal with clean engine oil prior to installation.
Using a new O-ring seal, install the RH CMP sensor and the bolt.
^
Tighten to 10 Nm (89 inch lbs.).
11. Connect the RH CMP sensor electrical connector.
12. Install the LH radio ignition interference capacitor and the nut.
^
Tighten to 10 Nm (89 inch lbs.).
13. NOTE: Lubricate the O-ring seal with clean engine oil prior to installation.
Using a new O-ring seal, install the LH CMP sensor and the bolt.
^
Tighten to 10 Nm (89 inch lbs.).
14. Connect the LH CMP sensor electrical connector.
15. Install the RH radio ignition interference capacitor and the nut.
^
Tighten to 10 Nm (89 inch lbs.).
16. NOTE: LH shown, RH similar
Connect the radio ignition interference capacitor electrical connectors.
17. Install the accessory drive belt tensioner and the 3 bolts.
^
Tighten to 25 Nm (18 ft. lbs.).
18. Install the coolant pump pulley and the 4 bolts.
^
Tighten to 25 Nm (18 ft. lbs.).
19. Install the 3 accessory drive idler pulleys and the 3 bolts.
^
Tighten to 25 Nm (18 ft. lbs.).
