Explorer 2WD V6-245 4.0L (1994)
2. Position the belt loop to the vehicle and install the retaining screw (two-door only).
3. Feed the floor anchor end of the front safety belt retractor and tongue through the quarter trim panel. Install quarter trim panel.
4. Position the floor anchor anti-rotation tab to the front floor pan. Install the bolt and tighten to 30-40 N.m (22-30 ft-lb).
5. Position safety belt guide. Install bolt and tighten to 30-40 N.m (22-30 ft-lb).
6. Install front seat shoulder strap guide cover.
7. Check the restraint system for proper operation.
Rear Safety Belts, Inboard
NOTE: Safety belt BUCKLES, center adjust tongues and belt and retractors can be replaced separately. However, if a safety belt assembly was in use
during a collision, the belt and retractor must be replaced as well as the center adjust tongue and belt and buckle assembly or the center adjust tongue and
the cable and BUCKLE assembly. When replacing safety belt and BUCKLE, safety cable and BUCKLE, center adjust tongues and belt and retractors,
use only the replacement parts specified in the Ford Master Parts Catalogs for the make and model of the vehicle being serviced. Safety belt assemblies
must not be interchanged between vehicle models.
Removal
1. Remove the bolts securing the rear safety belt and buckle to rear floor.
2. Remove rear safety belt and buckles from vehicle.
