Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
9. Install the forward clutch pressure plate and the original selective retaining ring.
(1) Install the forward clutch pressure plate.
(2) Install the forward clutch retaining ring.
CAUTION: The retaining ring is a select fit.
10. Air Check the forward clutch piston.
(1) Place the forward clutch cylinder with forward clutch piston facing down.
(2) Install the transmission center support on the forward clutch cylinder.
(3) Apply air pressure to the left port of the center support.
WARNING: AIR PRESSURE MUST NOT EXCEED 138 kPa (20 PSI). WEAR SAFETY GLASSES WHEN USING COMPRESSED
AIR. MAKE SURE THE DRUM IS FACING DOWN AS SHOWN.
11. Check forward clutch disc pack free play.
(1) Press down on forward clutch disc pack.
(2) Using a feeler gauge, check the gap between the forward clutch retaining ring and the forward clutch pressure plate.
-
If the clearance is not within specifications, install the correct size retaining ring.
