Explorer 2WD V8-4.6L (2008)
3. NOTE: Do not tighten the bolt at this time.
Install the shock absorber lower bolt and flag nut.
4. Using a suitable jack, raise the suspension until the distance between the center of the hub and the lip of the fender is equal to the measurement
taken in Step 1 (curb height).
5. Install the stabilizer bar link.
^
Tighten to 35 Nm (26 lb-ft).
6. Tighten the shock absorber lower bolt to 350 Nm (258 lb-ft).
7. Install the 3 shock absorber upper mount nuts.
^
Tighten to 30 Nm (22 lb-ft).
8. Remove the jack.
9. Install the wheel and tire.
10. Check and if necessary, align the front end.
Rear
Shock Absorber and Spring Assembly
Shock Absorber and Spring Assembly
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may
result in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do
not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of
correct retention of these parts.
