Explorer 2WD V8-4.6L VIN 8 (2006)
Heated seat
9. NOTE: Passenger seat shown, driver seat similar.
Disconnect the cushion and backrest heated seat mat electrical connectors.
All seats
10. Release the pin-type retainers, disconnect and route out the side air bag module electrical connector and wire harness.
11. Remove the safety belt buckle and pretensioner electrical connector cover.
12. Disconnect the safety belt buckle and pretensioner electrical connector and safety belt buckle switch electrical connector.
13. Release all the cushion trim cover retainers.
14. Remove the seat cushion foam pad and cushion trim cover.
15. Remove the 4 cushion frame-to-seat track nuts and the seat track.
-
To install, tighten to 36 Nm (27 lb-ft).
Driver seat with failed horizontal motor
16. If necessary, remove the inboard horizontal screw block bolt. This will allow the inboard power seat track to move independently so the safety belt
buckle and pretensioner can be removed.
All seats
17. To install, reverse the removal procedure.
18. Install the front seat and repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat