Explorer 2WD V8-4.6L VIN 8 (2006)
10. Remove the latch assemblies from the transmission cooler tubes.
11. Using the special tool, disconnect the transmission cooler tubes.
12. Remove the upper fan shroud bolts, then unclip the upper fan shroud from the lower fan shroud and remove the upper fan shroud.
^
To install, tighten to 7 Nm (62 inch lbs.).
13. Disconnect the fan clutch electrical connector.
14. Remove the fan clutch wiring harness bracket bolt.
^
To install, tighten to 10 Nm (89 inch lbs.).
15. NOTE: 4.6L (3V) engine shown, 4.0L SOHC engine similar.
Using the special tools, remove the cooling fan.
^
To install, tighten to 55 Nm (41 ft. lbs.).
16. Remove the bolts and the lower fan shroud.
