Explorer 2WD V8-4.6L VIN 8 (2006)
4. Use the special tool to install the A/C clutch field coil.
FS20 compressors only
4. Install the A/C clutch field coil.
5. Install the A/C clutch field coil snap ring.
All vehicles
6. NOTE: The A/C clutch pulley is a tight fit on the A/C compressor head. It must be correctly aligned during installation.
Install the A/C clutch pulley.
7. Install the A/C clutch pulley snap ring with the bevel side out.
8. Place one nominal thickness A/C clutch disc and hub spacer inside the clutch hub spline opening.
9. Install the A/C clutch disc and hub assembly.
10. Install the A/C clutch disc and hub bolt.
1. Hold the A/C clutch disc and hub with the special tool.
2. Install the A/C clutch disc and hub bolt.
-
Tighten to 13 Nm (10 lb-ft).
11. Measure and adjust the clutch air gap by removing or adding A/C clutch hub spacers.
12. Install the A/C compressor.