Explorer 2WD V8-4.6L VIN 8 (2006)
Accumulator HVAC: Service and Repair
SUCTION ACCUMULATOR
Removal and Installation
NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system except when there is physical evidence of
contamination from a failed A/C compressor or damage to the suction accumulator.
All vehicles
1. Recover the refrigerant.
2. Remove the PCM.
3. Remove the low-side service port stem bracket bolt.
-
To install, tighten to 8 Nm (71 lb-in).
4. Disconnect the A/C cycling switch electrical connector.
5. Remove the suction accumulator bolt.
-
To install, tighten to 9 Nm (80 lb-in).
6. Remove the suction accumulator stud.
-
To install, tighten to 9 Nm (80 lb-in).
4.6L vehicles
7. Remove the suction accumulator-to-compressor line bracket nut at the condenser-to-evaporator line bracket.