Explorer 2WD V8-4.6L VIN 8 (2006)
Expansion Valve: Service and Repair
THERMOSTATIC EXPANSION VALVE
Removal and Installation
NOTE:
-
An in-line filter is installed in the auxiliary evaporator inlet line at the floorpan bracket connection. A restriction in this filter may cause
misdiagnosis of a failed thermostatic expansion valve. This filter must be inspected before a new thermostatic expansion valve is installed.
-
Installation of a new suction accumulator is not required when repairing the air conditioning system, except when there is physical evidence of
contamination from a failed A/C compressor or damage to the suction accumulator.
1. Recover the refrigerant.
2. Remove the D-pillar trim panel.
3. Detach the rear portion of the LH quarter trim panel and position away from the thermostatic expansion valve.
4. Remove the 4 clips and the thermostatic expansion valve cover.
5. Remove the insulating tape.
-
Retain the tape for reuse.
