Explorer 4WD V6-4.0L (2009)
INSTALL the removed fuses. GO to T12.
-------------------------------------------------
T12 VERIFY VEHICLE EQUIPMENT - APIM
-
Inspect the vehicle for an APIM.
-
Is the vehicle equipped with an APIM?
Yes
GO to T13.
No
GO to T14.
-------------------------------------------------
T13 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE APIM DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: BJB Fuse 41 (15A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. Go To Pinpoint Test P. See: Pinpoint Test P: The Accessory Protocol Interface Module (APIM) Does Not Respond To
The Scan Tool
No
INSTALL the removed fuse. GO to T14.
-------------------------------------------------
T14 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE IC DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuses 8 (15A) and 24 (10A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. Go To Pinpoint Test G. See: Pinpoint Test G: The Instrument Cluster (IC) Does Not Respond To The Scan Tool
No
INSTALL the removed fuses. An intermittent fault is not present. Go To Pinpoint Test S. See: Pinpoint Test S: No High Speed Controller Area Network
(HS-CAN) Communication, All Modules Are Not Responding
-------------------------------------------------
Pinpoint Test U: No Power To The Scan Tool
Communications Network
Pinpoint Tests
Pinpoint Test U: No Power To The Scan Tool
