Explorer 4WD V6-4.0L (2009)
6. Raise the transmission and remove the transmission support insulator.
Installation
1. Install the transmission support insulator and the 2 transmission support insulator-to-extension housing screws.
-
Tighten to 90 Nm (66 lb-ft).
2. Lower the transmission and install the 2 transmission support insulator-to-crossmember nuts.
-
Tighten to 90 Nm (66 lb-ft).
3. If equipped, install the skid plate and skid plate bolts.
-
Tighten to 24 Nm (18 lb-ft).