Explorer 4WD V6-4.0L VIN E (1999)
5. Install Dial Indicator with Bracketry on the transmission case.
1
Position the indicator on the piston pad.
2
Set the dial indicator to zero.
6. NOTE: If the piston travel in this step is 3 - 5.6 mm (0.120 - 0.220 inch), it is within specification. If the piston travel is greater than 5.6 ram
(0.220 inch), use the next longer piston and rod. If the piston travel is less than 3 mm (0.120 inch), use the next shorter piston and rod.
Back out the servo gauge adjusting screw until it bottoms out on the tool. Record the distance the servo piston traveled.
7. CAUTION: Make sure the test spring is removed after this step.
Use the above procedure to check the piston travel with the newly selected low/reverse band servo piston and rod (if required) to make sure that
the piston travel is 3 - 5.6 mm (0.120 - 0.220 inch). Remove the servo gauge and the low/reverse band servo return spring.
-
Grooves are located on low/reverse band servo rod.
