Explorer Sport 2WD V6-4.0L VIN E (2002)
1. Using a suitable press, install the wheel stud in the brake disc and hub.
2. CAUTION: When installing the ABS sensor ring, make sure the sensor ring is pressed on straight.
Position a new ABS sensor ring on the hub. Using a cylinder with 79 mm (3.16 inch) inside diameter and 96 mm (3.84 inch) outside diameter,
press the ring onto the hub until the ring seats against the shoulder in the hub.
3. Install the brake disc and hub.
1
Position the brake disc and hub.
2
Install the outer front wheel bearing.
3
Install the front wheel outer bearing retainer washer.
4
Install the spindle nut.
4. Tighten the spindle nut while rotating the brake disc and hub.
