Explorer Sport Trac 2WD V6-4.0L (2009)
6. Install the rear driveshaft.
4WD vehicles
7. Position the output shaft seal.
8. Using the 6R80 Rear Seal 4X4 Installer, install a new output shaft seal.
9. Install the transfer case.
All vehicles
10. Fill and check the transmission fluid. For additional information, refer to Transmission Fluid Level Check See: Service and
Repair/Procedures/6R80/Transmission Fluid Level Check.
Manual Control Lever Shaft and Seal
Manual Control Lever Shaft and Seal
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the selector lever cable heat shield.