Explorer Sport Trac 2WD V6-4.0L VIN K (2007)
1
Position the clamp on the interconnecting shaft.
2
Position the boot on the interconnecting shaft.
3
Install the tri-lobe insert.
6. Using the special tool, install the CV joint.
7. Install the retainer circlip.
8. For the inboard CV joint:
1
Pack the inboard CV joint housing with 250 grams (8.82 oz.) of grease.
2
Spread any remaining grease evenly inside the boot and CV joint.
3
Install the inboard CV joint housing, seating the boot in the groove in the housing.
9. Set the halfshaft assembled length to specifications.
1
Measure the entire assembly length.
