F 150 2WD V8-4.6L VIN 8 (2009)
5. Turn the ignition to OFF.
Tool Link(TM) Reader
Tool Link(TM) Reader
Removal and Installation
1. Pull back the carpet from the LH side of the passenger compartment rear interior wall.
2. NOTE: Support the Tool Link(TM) reader while the 2 screws are being removed. Do not allow it to hang from the electrical connectors.
Remove the 2 screws and the Tool Link(TM) reader.
-
Disconnect the electrical connectors.
-
If the Tool Link(TM) reader is being replaced, cut the power/ground feed from the vehicle electrical harness.
3. To install, reverse the removal procedure.
-
If a new Tool Link(TM) is being installed, splice the new power/ground feed to the vehicle electrical harness.
