F 150 2WD V8-5.4L Flex Fuel (2008)
19. Using the special tools, raise the engine.
RH engine support insulator
20. Remove the 3 RH engine support insulator bracket-to-cylinder block bolts.
21. Remove the RH engine support insulator.
LH engine support insulator
22. Remove the 3 LH engine support insulator bracket-to-cylinder block bolts.
23. Remove the LH engine support insulator.
Installation
LH engine support insulator
1. NOTE: Clean the engine support insulator-to-bracket mating surface of any dirt or foreign material prior to installation.
Position the LH engine support insulator into the vehicle.
2. NOTE: Clean the engine support insulator bracket-to-cylinder block mating surfaces of any dirt or foreign material prior to installation.
Install the 3 LH engine support insulator bracket-to-cylinder block bolts.
^
Apply Threadlock(R) to the bolt threads prior to installation.
^
Tighten to 63 Nm (46 lb-ft).
RH engine support insulator
3. NOTE: Clean the engine support insulator-to-bracket mating surface of any dirt or foreign material prior to installation.
Position the RH engine support insulator into the vehicle.
4. NOTE: Clean the engine support insulator bracket-to-cylinder block mating surfaces of any dirt or foreign material prior to installation.
Install the 3 RH engine support insulator bracket-to-cylinder block bolts.
^
Apply Threadlock(R) to the bolt threads prior to installation.
^
Tighten to 63 Nm (46 lb-ft).
All vehicles