F 150 2WD Pickup V8-4.6L SOHC VIN W (1998)
6. Apply the silicone at the rear oil seal retainer to cylinder block sealing surface.
-
Use Ford Silicone Gasket and Sealant F6AZ-1956-AA or equivalent meeting Ford specification WSE-M4G323-A6.
7. Position the oil pan gasket.
8. Install the oil pan bolts and torque in the three steps, in the sequence shown.
-
Step 1: Tighten to 2 Nm (18 inch lbs.).
-
Step 2: Tighten to 20 Nm (15 ft. lbs.).
-
Step 3: Tighten an additional 60 degrees.
9. Position a suitable jack under the rear axle.
10. Place suitable jacks under the engine and lift the engine to remove the blocks.
