F 150 4WD V8-4.6L VIN 8 (2010)
Seat Cover: Customer Interest
Interior - Seat Cushion Cover Loose
TSB 10-20-7
10/25/10
SEAT CUSHION COVER LOOSE / J-CLIP RETENTION
FORD:
2009-2010 F-150
This article supersedes TSB 09-20-2 to remove the production build date, update the vehicle model years and Service Procedure.
ISSUE
Some 2009-2010 F-150 vehicles may have a seat cushion cover that appears loose near the front of the seat. This may be caused by the seat cushion
cover j-retainer becoming disengaged from the seat cushion pan flange.
ACTION
Follow the Service Procedure steps to correct the condition.
SERVICE PROCEDURE
Install two (2) retention clips on the seat cushion cover j-retainer.
The following procedure and parts are applicable to all 2009-2010 F-150 front seat configurations, trim levels, right and/or left side.
1. Position the affected seat rearward.
2. Completely disengage the j-retainer from the seat cushion pan flange.
3. Install one (1) clip on each side of the j-retainer, approximately 1/4" to 1" (5 mm to 25 mm) from the outboard edge. Right hand seat shown. (Figure
1)
4. Secure the j-retainer to the seat cushion pan flange. To aid in assembly, begin at the inboard edge of the flange, working outboard.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
102007A
2009-2010 F-150: Install
0.2 Hr.
Retention Clip(s), One Or
Both Front Seats (Do Not
