F 150 4WD V8-4.6L VIN 8 (2010)
6. Disconnect the main tail lamp connector. If equipped, disconnect the reverse parking aid harness connector and the reverse camera wiring harness.
7. Disconnect the license lamp connectors.
8. Remove the axle vent tube clip from the pickup bed floor crossmember and position the tube to the side.
9. If equipped, remove the 2 upper bolts from the side step bracket-to-bed.
-
Tighten to 22 Nm (16 lb-ft).
10. If equipped, loosen the lower side step bracket-to-step bolt and position the bracket so it will rest on the step housing.
-
To install, tighten to 55 Nm (41 lb-ft).
