F 150 4WD V8-4.6L VIN 8 (2010)
-
Ignition OFF.
-
Disconnect: Negative Battery Cable.
-
Measure the resistance between the ACM C290a-13, circuit GD114 (BK/BU), harness side and ground.
-
Is the resistance less than 5 ohms?
Yes
GO to K3.
No
REPAIR the circuit. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
K3 CHECK THE MS-CAN CIRCUITS BETWEEN THE ACM AND THE DLC FOR AN OPEN
-
Disconnect: ACM C290c.
-
Measure the resistance between the ACM C290c-15, circuit VDB06 (GY/OG), harness side and the DLC C251-3, circuit VDB06 (GY/OG),
harness side.
-
Measure the resistance between the ACM C290c-16, circuit VDB07 (VT/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG),
harness side.
-
Are the resistances less than 5 ohms?
Yes
CONNECT the negative battery cable. GO to K4.
No
REPAIR the circuit in question. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
K4 CHECK FOR CORRECT ACM OPERATION
-
Disconnect all the ACM connectors.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect all the ACM connectors and make sure they seat correctly.
