ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3229 > < Initial Inspection and Diagnostic Overview|Page 3227
Page 112
background image

-

Are the resistances less than 5 ohms?

Yes

REPAIR the DLC or REPAIR the circuit in question. CONNECT all modules. CLEAR the DTCs. REPEAT the network test with the scan tool.

No

A capacitor internal to a module may still be draining, causing irregular resistance readings. WAIT 5 minutes. REPEAT the pinpoint test.

-------------------------------------------------
Y11 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE PCM DISCONNECTED

 

-

Disconnect: PCM C175b.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with a Transmission Control Module (TCM), GO to Y12.

If the vehicle is not equipped with a TCM, GO to Y13.

No

CONNECT the negative battery cable. GO to Y31.

-------------------------------------------------
Y12 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE TCM DISCONNECTED

 

-

Disconnect: TCM C1575.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to Y13.

Initial Inspection and Diagnostic Overview|Page 3229 > < Initial Inspection and Diagnostic Overview|Page 3227