ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3231 > < Initial Inspection and Diagnostic Overview|Page 3229
Page 114
background image

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with a Trailer Brake Control (TBC) module, GO to Y16.

If the vehicle is not equipped with a TBC module, GO to Y17.

No

CONNECT the negative battery cable. GO to Y35.

-------------------------------------------------
Y16 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE TBC MODULE DISCONNECTED

 

-

Disconnect: TBC Module C2142.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to Y17.

No

CONNECT the negative battery cable. GO to Y36.

-------------------------------------------------
Y17 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE OCSM DISCONNECTED

 

-

Disconnect: Occupant Classification System Module (OCSM) C3159.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with an Accessory Protocol Interface Module (APIM), GO to Y18.

If the vehicle is not equipped with an APIM, GO to Y19.

Initial Inspection and Diagnostic Overview|Page 3231 > < Initial Inspection and Diagnostic Overview|Page 3229