F 150 4WD Pickup V8-5.4L CNG VIN M (2001)
Special Tools
Special Tool(s)
Removal
1. Remove the differential case.
2. Mark the driveshaft flange and the pinion flange for correct alignment during installation.
3. Remove the four driveshaft bolts.
4. CAUTION: The driveshaft centering socket yoke fits tightly on the rear axle pinion flange pilot. Never hammer on the driveshaft or any of its
components to disconnect the yoke from the flange. Pry only in the area shown with a suitable tool to disconnect the yoke from the flange.
