F 250 2WD Super Duty V10-6.8L (2009)
Seat Track: Service and Repair
Seat Track - Front, Bench Seat
Seat Track - Front, Bench Seat
Removal
1. Remove the seat. For additional information, refer to Seat - Front, Bench See: Service and Repair/Front Seats/Seat - Front, Bench.
2. Remove the 4 riser-to-track nuts and remove the LH and RH risers.
-
To install, tighten to 50 Nm (37 lb-ft).
3. Position the seat tracks to access the track-to-cushion frame front bolts.
4. Remove the 2 seat track-to-cushion frame bolts.
-
To install, tighten to 25 Nm (18 lb-ft).
5. Position the seat tracks to access the track-to-cushion frame rear bolts.
6. Remove the 2 seat track-to-cushion frame rear bolts and seat track assembly.
-
To install, tighten to 25 Nm (18 lb-ft).
7. Remove the 3 seat track adjusting bar-to-track bolts.
-
To install, tighten to 12 Nm (106 lb-in).
8. To install, reverse the removal procedure.
