F 250 2WD Super Duty V10-6.8L (2009)
-
Stage 1: Tighten to 30 Nm (22 lb-ft).
-
Stage 2: Tighten an additional minimum of 60 degrees.
5. Position the RH engine support insulator into the vehicle.
All engine support insulators
6. Using the Engine Support Bar, Support Hook and Engine Support Bracket, lower the engine.
LH engine support insulator
7. NOTICE: Only use hand tools when installing the engine support insulator nuts or damage to the engine support insulator may occur.
Install 3 new LH engine support insulator nuts.
-
Tighten to 200 Nm (148 lb-ft).
8. NOTICE: Only use hand tools when installing the engine support insulator nuts or damage to the engine support insulator may occur.
Install 4 new RH engine support insulator nuts.
-
Tighten to 115 Nm (85 lb-ft).
9. NOTICE: Only use hand tools when installing the engine support through bolt or damage to the engine support insulator may occur.
Install a new LH engine support insulator through bolt.
-
Tighten to 350 Nm (258 lb-ft).
10. NOTICE: Only use hand tools when installing the engine support through bolt or damage to the engine support insulator may occur.
Install a new RH engine support insulator through bolt.
-
Tighten to 350 Nm (258 lb-ft).
11. Install the oil cooler. For additional information, refer to Oil Cooler See: Engine Lubrication/Oil Cooler/Service and Repair.
RH engine support insulator
12. NOTICE: Only use hand tools when installing the engine support insulator nuts or damage to the engine support insulator may occur.
Install 4 new RH engine support insulator nuts.
-
Tighten to 115 Nm (85 lb-ft).
13. NOTICE: Only use hand tools when installing the engine support insulator nuts or damage to the engine support insulator may occur.
Install 3 new LH engine support insulator nuts.
-
Tighten to 200 Nm (148 lb-ft).
14. NOTICE: Only use hand tools when installing the engine support through bolt or damage to the engine support insulator may occur.
Install a new LH engine support insulator through bolt.
-
Tighten to 350 Nm (258 lb-ft).
