F 250 2WD Super Duty V8-5.4L (2008)
Stabilizer Link: Service and Repair
Front
Stabilizer Bar and Link - F-250, F-350
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can
result in major service expense. They must be replaced with the same part number or an equivalent part if replacement is necessary. Do not
use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of
correct retention of these parts.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove and discard the stabilizer bar link upper nuts, washers and bolts.
^
To install, tighten to 133 Nm (98 ft. lbs.).
3. Remove the stabilizer bar link lower nuts, washers, bolts and the stabilizer bar links.
