F 250 2WD Super Duty V8-5.4L (2008)
4. Position the cables and install the starter solenoid terminal eyelet nuts and ground cable stud bolt.
^
Tighten the ground cable stud bolt to 10 Nm (89 inch lbs.).
^
Tighten the starter solenoid B-terminal nut to 12 Nm (9 ft. lbs.).
^
Tighten the starter solenoid S-terminal nut to 5 Nm (44 inch lbs.).
5. Install the terminal cover.
6. Install the exhaust system Y-pipe.
7. Connect the battery. For additional information, refer to Battery.
Early build vehicles
8. Install the remote mount transmission fluid filter bracket and bolts.
^
Tighten to 35 Nm (26 ft. lbs.).
9. Install the remote mounted transmission fluid filter and install the filter-to-bracket bolt.
^
Tighten to 11 Nm (8 ft. lbs.).
10. CAUTION: A backup wrench must be used on the remote mounted transmission fluid filter housing while disconnecting and connecting
the transmission fluid cooler tubes or damage to the filter housing will occur.
Using a backup wrench, connect the rear transmission fluid cooler tubes to the remote mounted transmission fluid filter.
^
Tighten to 40 Nm (30 ft. lbs.).
