F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
Condenser HVAC: Service and Repair
CONDENSER CORE
Removal and Installation
NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system, except when there is physical evidence of
contamination from a failed A/C compressor or damage to the suction accumulator.
1. Recover the refrigerant.
2. Remove the horn assembly bolt and position the horn assembly aside.
-
To install, tighten to 11 Nm (8 lb-ft).
3. Remove the 2 LH upper radiator air seal pin-type retainers.
4. Remove the RH upper radiator air seal pin-type retainer.
5. Remove the condenser inlet and outlet fitting nuts and disconnect the fittings.
-
Discard the O-ring seals and gasket seals.
-
To install, tighten to 15 Nm (11 lb-ft)
6. Remove the 2 condenser bolts.
-
To install, tighten to 11 Nm (8 lb-ft).
7. Remove the condenser core.
8. To install, reverse the removal procedure.
