F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
5. Position the driveshaft slip yoke in the U-Joint Tool and press out bearing. If bearing cup cannot be pressed all the way out of the driveshaft slip
yoke, remove it with vise grip or channel lock pliers.
6. Reposition the driveshaft slip yoke in U-Joint Tool 180 degrees from previous position. Press on the spider and remove the remaining bearing cup
from the opposite side.
7. Remove driveshaft slip yoke from the spider.
8. Remove the remaining bearing cups, spiders and driveshaft flange yoke from the driveshaft in the same manner.
9. Clean all foreign matter from the yoke area at each end of the driveshaft.
ASSEMBLY
1. Start a new bearing cup into the driveshaft yoke.
NOTE: Universal joint kits are to be installed as complete assemblies only. Do not mix components from other universal joints.
2. Position the new spider in the driveshaft yoke and press the bearing cup 6.3 mm (1/4 inch) below the yoke surface using U-Joint Tool
T74P-4635-C.
3. Remove driveshaft from U-joint tool and install a new snap ring.
4. Start a new bearing cup into the opposite side of the yoke. Check needles for proper position.
5. Position driveshaft in U-joint tool and press on the bearing cup until the opposite bearing cup contacts the snap ring.
6. Remove the driveshaft from tool and install a new snap ring. Check snap ring for proper seating.
NOTE: Assemble universal joint using the yellow snap rings supplied in the kit. If difficulty is encountered with yellow snap rings, install the
